So many little things

I’ve learned that the faster speeds of the circulation pump move a lot more heat. Like maybe in magnitude of speed if they were numbered (from one to three)? I prefer to run it on one/low as it uses less energy and is quiet.

For now I run the pump when the stove has an active fire. Come winter it just runs and runs and runs!

Since the point is to move the heat into the floor, I’ve insulated the pump for two reasons. It generates heat while pumping (in fact, some “plug and play” hot tubs use the heat from the circulator to heat the water. It’s incredibly efficient, but of course has drawbacks). That heat ought to be used efficiently instead just wandering off! The insulation will help limit the sound too. S

ince the simplification of the pump and there aren’t any lights or anything (I might upgrade to switch to a lit toggle when operating) I used some colorful duct tape to bring attention to the controls. (I’m not the only person that uses the place, and I’m gently moving towards the reality that I won’t live here “forever” and in fact may winter elsewhere in the not so distant future.

For the immediate future I’ll be insulating more of the pipes that move the heat and upgrading the (insulation and its protective) lining in the stove

Leave a Reply